目次

Preface Section 1 : Fluid Mechanics Experiments and Demonstrations Chapter 1: Determining the Net Positive Suction Head of a Magnetic Drive Pump 1.1 Introduction 1.2 Equipment and Procedures 1.3 Results and Discussion 1.4 Conclusions and Recommendations 1.5 Nomenclature 1.6 References 　 Chapter 2: Bernoulli Balance Experiments Using a Venturi 2.1 Introduction 2.2 Commercial Venturi Experiment 2.3 Funnel Venturi Experiment 2.4 Nomenclature 2.5 References 　 Chapter 3: Force Produced by Impingement of a Fluid Jet on a Deflector 3.1 Introduction 3.2 Equipment and Procedures 3.3 Experimental Results 3.4 Data Reduction 3.5 Discussion of Results 3.6 Conclusions 3.7 Nomenclature 3.8 References 　 Chapter 4: Applying the Bernoulli Balance to Determine Flow and Permanent Pressure Loss 4.1 Introduction 4.2 Experimental 4.3 Experimental Data and Measured Flow Rate 4.4 Model Development 4.5 Reduced Results and Discussion 4.6 Conclusions 4.7 Nomenclature 4.8 References   Chapter 5: A Simple Sharp-edged Orifice Demonstration 5.1 Introduction 5.2 Experimental 5.3 Experimental Data 5.4 Model Development 5.5 Reduced Results and Discussion 5.6 Conclusions 5.7 Nomenclature 5.8 Acknowledgment 5.9 References 　 Chapter 6: Depressurization of an Air Tank 6.1 Introduction 6.2 Experimental 6.3 Experimental Data 6.4 Model Development 6.5 Results and Discussion 6.6 Conclusions 6.7 Nomenclature 6.8 Acknowledgment 6.9 References 　 Chapter 7: Draining an Upper Tank Into a Lower Tank: Experimental and Modeling Studies 7.1 Introduction 7.2 Experimental 7.3 Experimental Data 7.4 Reduction of Experimental Data 7.5 Reduced Results 7.6 Discussion of Results, Conclusions and Recommendations 7.7 Nomenclature 7.8 References 　 Chapter 8: Determining the Pump Curve and the Efficiency for a Bomba BP-50 Regenerative Centrifugal Pump 8.1 Introduction 8.2 Experimental 8.3 Data Reduction 8.4 More About the Regenerative Pump 8.5 Results and Discussion 8.6 Conclusions and Recommendations 8.7 Nomenclature 8.8 References Appendix   Section 2: Heat Transfer Experiments and Demonstrations Chapter 9: Thermal Conductivity and Radiative Experiments Measurement 9.1 Thermal Conductivity of Sheet and Granular Materials 9.2 Radiative Absorptivity of Metallic Surfaces 9.3 Conclusions 9.4 Nomenclature 9.5 References 　 Chapter 10: Free Convection Heat Transfer from Plates 10.1 Free Convection Heat Transfer from an Upward Facing Horizontal Plate 10.2 Free Convection Heat Transfer from a Vertical Plate 10.3 Conclusions 10.4 Nomenclature 10.5 Acknowledgment 10.6 References 　 Chapter 11: Forced Convection Heat Transfer by Air Flowing Over the Top Surface of a Horizontal Plate 11.1 Introduction 11.2 Experimental Equipment List 11.3 Experimental Procedure 11.4 Data Reduction 11.5 Comparison of Experimental Results with Values from the Literature 11.6 Improved Experiment 11.7 Conclusions 11.8 Nomenclature 11.9 Acknowledgment 11.10 References 　 Chapter 12: Laminar Forced Convection Inside a Coiled Copper Tube 12.1 Introduction 12.2 Experimental 12.3 Data Reduction 12.4 Comparison of Experimental Results with Correlation 12.5 Conclusions 12.6 Nomenclature 12.7 References 　 Chapter 13: An Experimental Testing of Turbulent Forced Convection Inside Tubes 13.1 Introduction 13.2 Experimental 13.3 Data Reduction 13.4 Comparison of Experimental Results with Correlation 13.5 Conclusions 13.6 Recommendations 13.7 Nomenclature 13.8 references 　 Chapter 14: Forced Convection Through an Annulus 14.1 Introduction 14.2 Experimental Equipment List 14.3 Experimental Procedure 14.4 Safety Concerns 14.5 Experimental Data 14.6 Data Reduction 14.7 Comparison of Experimental Results with Values from the Literature 14.8 Improved Experiment 14.9 Conclusions 14.10 Nomenclature 14.11 Acknowledgment 14.12 References 　 Chapter 15: Experimental Investigation and Modeling Studies of the Transient Cooling of a Brass Rod Subjected to Forced Convection of Room Air 15.1 Introduction 15.2 Experimental 15.3 Raw Experimental Results 15.4 Model Development: Heat Transfer Coefficient at the Rod Surface 15.5 Reduced Results 15.6 Discussion of Results 15.7 Conclusions 15.8 Recommendations 15.9 Nomenclature 15.10 References 　 Chapter 16: Solar Flux and Absorptivity Measurements 16.1 Introduction 16.2 Experimental Equipment and Supplies List 16.3 Experimental Procedure 16.4 Experimental Results 16.5 Simulation and Data Reduction 16.6 Results and Discussion 16.7 Conclusions 16.8 Nomenclature 16.9 References 　 Chapter 17: A Transient Experiment to Determine the Heat Transfer Characteristics of a 100 W Incandescent Light Bulb, Operating at 48 W 17.1 Introduction 17.2 Equipment and Procedures 17.3 Experimental Results 17.4 Data Reduction 17.5 Discussion of Results 17.6 Conclusions 17.7 Nomenclature 17.8 References 　 Chapter 18: Experimental Determination of a Room Heat Transfer Coefficient by Transient Cooling of a Mercury in Glass Thermometer 18.1 Introduction 18.2 Experimental 18.3 Raw Experimental Data 18.4 Reduction of Experimental Data 18.5 Reduced Results 18.6 Discussion of Results 18.7 Conclusions 18.8 Recommendations 18.9 Nomenclature 18.10 Acknowledgment18.11 References 　 Chapter 19: Experimental Determination and Modeling of the Temperature Distribution Along a Hollow Fin 19.1 Introduction 19.2 Experimental 19.3 Raw Experimental Data 19.4 Reduction of Experimental Data: Determining the Heat Transfer Coefficient for Crossflow over a Cylinder 19.5 Reduced Results 19.6 Discussion of Results 19.7 Conclusions 19.8 Recommendations 19.9 Nomenclature 19.10 References